The increasing bandwidth requirements, driven by next-generation camera-based driver assistance systems in the first place, make Ethernet the ideal means for data networks in vehicles, Continental said. With a robust bandwidth of 100 Mbit/s and the usage of simple, cost-effective unshielded two-wire copper cable, Ethernet will connect all relevant ECUs, antennas and sensors, the company explained. With this position, Continental was among the first tier ones to commit to Ethernet; the company announced to support Ethernet already earlier this year.
Now Continental has submitted a kind of roadmap for the roll-out of Ethernet. In the first step, the electronics provider plans to equip the Interior and chassis & Safety domains with Ethernet since in these domains wiring is a relatively easy task. Later, the cars could be networked entirely with Ethernet, doing away with technologies today in use but with much lower performance. For these the next steps, the relatively long automotive design cycles apply: First products will be available in 2015. Gradually, Ethernet will conquer all automotive domains. "Until 2020, we can imagine to have first pre-development projects with Ethernet in all domains", Continental writes in a press release.
Ethernet would make a plentitude of benefits available to carmakers - benefits that other segments of the IT world already could use for decades but were not accessible for in-car networking designers because of the extreme EMC requirements in vehicles. "Ethernet will help to reduce the total vehicle costs and at the same time increase functionality," explained Continental board member Helmut Matschi.
In a cost comparison against MOST, Ethernet would allow to implement solutions 15 to 20% cheaper, Continental said. The comparison included the electric and electronic components as well as the cabling. And pricing is not the only advantage of Ethernet over MOST. The optical networks used in MOST applications are much more difficult to handle because of their relatively high diameter and bending radius. "Handling MOST cables in