The IC drives six 250 nC NFETS up to 25k Hz, while keeping 10 V gate voltage down to 7V battery voltage . In line with the needs for such fail safe torque control applications, the MLX83203 features extensive diagnostics as well as a high speed, low noise amplifier. Rather than configuring the pre-driver by applying external resistors, 6 bytes of on-chip EEPROM offer wide-ranging configuration options while minimizing pin count.
The low self heating and small pin count means that the MLX83203 presents the smallest footprint for comparable 3 phase pre-drivers on the market. The benefit is a smaller finished size, fewer components and more flexibility for design re-use. Additional family members are planned for release in the coming months. The MLX83203 will be released for operation up to 150 °C and qualification to 175 °C is planned for the near future. Further members of this product family will support medium current capability and DC motor control.
The wide operating voltage range from 4.5 V to 28 V, plus bootstrap topology complemented with a charge pump stage, allow operating of the power stage via standard level NFETs without loss of performance during stop/start conditions, as well as enabling control even during engine cranking. The charge pump can be configured for applying a high side NFET reverse polarity protection. In sleep mode the IC consumes less than 30 µA standby current. A 10 MHz gain bandwidth product (GBW) delivers shunt amplifier settling times of less than 1µs for fast current feedback. Its gain can be programmed in a wide range from 8 up to 48, and the input range can be configured from fully symmetric to full scale.The power stage (VDS, VGS) as well as all input voltages are monitored with comparators to offer maximum system level diagnostics. A high speed serial interface provides detailed diagnostics feedback to the microcontroller.
Thanks to its wide configurability and high operating temperature, the