Tool speeds design of CAN, LIN, FlexRay and MOST systems

May 05, 2015 // By Christoph Hammerschmidt
The OptoLyzer Studio software from K2L GmbH supports hardware development tools in the area of in-car data networking with systems such as CAN, LIN, FlexRay or MOST. Facilitating and streamlining the design process of these data bus components, the software helps users to reduce cost and speed design cycles.

 While the range of OptoLyzer Studio includes tools from third-party vendors such as MOST chip manufacturer Microchip, its effect is best if combined with the ATS vehicle test software from K2L. The scope of its functionalities ranges from test and simulation to post processing and verification. The OptoLyzer Studio helps reducing complexity and cost. Time-to-market can be reduced across all process components in the area of test and simulation. At the same time, it covers all requirements regarding analysis and verification, which effectively benefit quality assurance even at the earliest stages of development. In addition to supporting the most relevant automotive data bus systems, this .NET based tool leverages cost-efficient open technologies which allow customer-specific add-ons. These features make the OptoLyzer Stuido a flexible development tool for the entire automotive industry.

The Entry Edition of the tool carries a price tag of $390.

More information: