The INLC10AQ can be used to build customer-specific LED chains that can be controlled via a bidirectional differential two-wire bus. Thus, up to 4079 LED drivers and controllers can be interconnected in a single array via daisy chain. In addition, smart LED modules, which integrate drivers & controllers and RGB LEDs in one package, are also available from various manufacturers in volume quantities and with qualification for the automotive industry.
The Inova INLC10AQ offers functions such as color/brightness control and dimming of the lighting. It supports LED brightness calibration and color temperature compensation of red LEDs over the dominant wavelength. The built-in one-time programmable (OTP) memory stores calibration and compensation data values, eliminating the need for LED binning. During the development of the driver / controller chip, the oscillator was integrated, so no additional external components are required. The chip requires only a single supply voltage and also contains a built-in LDO (linear voltage regulator), a temperature sensor and comprehensive diagnostic functions.
LED chains can be daisy-chained to multiple INLC10AQ devices or other Iseled products via a differential bidirectional serial bus with 2 Mbps and CRC (Cyclic Redundancy Check). The chip contains three independent constant current sinks, each controlled by PWM (488 Hz, 12 bit). In a LED chain, each chip is individually addressable via the serial bus with a proprietary bus protocol.